Sony MVS-6520 User Manual page 72

Multi format switcher system with icp-series control panel
Hide thumbs Also See for MVS-6520:
Table of Contents

Advertisement

CUT button
AUTO TRANS button
Transition control block
To execute a transition on a switcher bank by a button
operation, use the following procedure in the transition
control block.
To carry out an instantaneous cut transition: Press the
[CUT] button.
To carry out a gradual transition: Press the [AUTO
TRANS] button.
This executes the transition at the preset transition rate
(1 p.
68).
While the transition is executing, the [AUTO TRANS]
button lights amber. When it completes the button
turns off.
To complete a partially executed transition
instantaneously: Press the [CUT] button.
The [AUTO TRANS] button turns off.
Executing a Transition with the
Fader Lever (Manual Transition)
Using the fader lever, you can manually control the
progress of transition from the current video to the new
video using the transition effect selected as the transition
type. Moving the fader lever from one end of its travel to
the other completes the transition.
To execute a manual transition with the transition control
block fader lever, use the following procedure.
To carry out the transition completely: Move the lever
over the full range of its travel.
To pause a partly executed transition: Stop moving the
fader lever.
72
Executing a Transition
To resume a paused transition: Resume moving the
fader lever.
Combining Auto and Manual
Transitions
Using the [AUTO TRANS] button, the [CUT] button, and
the fader lever, use the following procedures.
Moving the fader lever during an auto
transition
During an auto transition started by pressing the [AUTO
TRANS] button, operating the fader lever immediately
enables the fader lever, and the [AUTO TRANS] button
Fader lever
turns off. Thereafter, the fader lever controls the progress
of the transition.
Executing an auto transition after partly
moving the fader lever
• Press the [CUT] button to instantaneously complete the
transition.
• Press the [AUTO TRANS] button to complete the rest of
the transition at the preset transition rate.
If the transition rate is set to 100 frames, and the fader
lever has moved through
remaining
frames.
Non-Sync State
If the fader lever is in an intermediate position when a
transition is completed as an auto transition, then the lever
position no longer agrees with the transition state. This is
termed a "non-sync state."
In a non-sync state, the [Non Sync] or [Sync] indicator
indicates the position from which a normal transition can
be carried out. This is at both end positions of the fader
lever travel.
• If you move the fader lever toward the [Non Sync]
indicator, transition is not executed, and the non-sync
state will be released and the [Non Sync] indicator will
disappear when you reach the end of the lever travel.
• If you move the fader lever toward the [Sync] indicator,
the transition resumes, and the [Sync] indicator will
disappear when you reach the end of the lever travel. In
this case, a 100% transition is executed in the remaining
section.
1
/
of the transition, then the
4
3
/
of the transition is carried out in 100
4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents