Misc Menu Operations - Sony MVS-6520 User Manual

DME channel copy and swap
You can copy and swap the channel data among DME
channels 1 to 2 (MKS-6570) or DME channels 5 to 8
(MVE-8000A/9000).
It is not possible to copy or swap the channel data between
DME channels 1 to 2 and DME channels 5 to 8.
Copying format converter data
You can copy data between format converter inputs.
Similarly, you can copy format converter data between
outputs.
Notes
The copy source and destination data must be in the same
signal format.
Copy and Swap Operations
Copy and Swap Using Menus
Copy and swap operations are performed using the Copy/
Swap menu.
Select the following targets for operation in the Copy/
Swap >Copy/Swap menu. For format converter
operations, use the Copy/Swap >Copy menu.
This section describes copy and swap operations for wipe
data as an example.
• M/E: Copying and swapping M/E data
• Key: Copying and swapping key data
• Wipe: Copying and swapping wipe data
• DME Wipe: Copying and swapping DME wipe data
• Matte: Copying and swapping matte data
• Color: Copying and swapping color data
• DME: Copying and swapping data by DME channels
• Format Converter: Copying format converter data
For an overview of copy and swap operations,
1 "Overview of Copy and Swap" (p.
Copy and swap menu operations
To copy or swap wipe data, use the following procedure.
1
Open the Copy/Swap >Copy/Swap >Wipe menu
(3113).
The status area shows lists for the copy/swap source on
the left, and the copy/swap destination on the right.
2
In the <Data Select> group, select either of the
following.
Wipe: Applies operations to wipes in the transition
control block.
Key Wipe: Applies operations to wipes in the
independent key transition control block.
3
4
To undo a copy or swap
Press [Undo] to return to the state before the copy or swap
was carried out.
Copying using button operations
You can copy keyer data using the key delegation buttons
in the transition control block.
Basic button operation
The basic button operation is to hold down the copy source
button, then press the destination button.
You can undo the last operation using [Undo] in the menu
(1 p.
To copy from M/E-1 key 1 to PGM/PST key 2
While holding down the [KEY1] transition control block
button in the M/E-1 bank, press the [DSK2] transition
control block button in the PGM/PST bank.

Misc Menu Operations

In the Misc menu, you can carry out the following
operations.
• Enabling or disabling control from an external device or
the System Manager.
• Enabling or disabling side flags for each background bus
of each of the switcher banks.
For details about the side flag function,
(p.
• Switching the safe title function on or off for each
switcher output.
147).
• Displaying the transition rate, independent key transition
rate, and fade-to-black transition rate for each of the
switcher banks, and changing the settings.
• Enabling or disabling the AUX mix function (ON/OFF)
and setting the transition rate.
Port Settings for Control from an
External Device
Enabling or disabling control from an
external device
1
Select the copy/swap source data and copy/swap
destination data (1 p. 147)
.
Press [Copy] to copy, or press [Swap] to swap.
149).
154).
Open the Misc >Enable >Port Enable menu (3211).
1 "Side Flags"
149
Misc Menu Operations