Wave Settings - Sony MVS-6520 User Manual

To turn an effect off
In the setting menu, press the button for the effect name,
turning it off, or press [OFF] in the lower right part of the
screen in the Non Linear menu.

Wave Settings

There are two modes: H&V and Size. You can set the size
and frequency of the waves, the wave form, the amount of
wave movement, and the range. In H&V mode, you can
also set the wave angle.
Applying the Wave effect
1
In the <Mode> group of the Non Linear >Wave menu
(4141.1), select the wave modulation mode.
H&V: Modulate vertically and horizontally without
changing the size of the image. This mode allows
waves to be created in both the vertical and
horizontal directions at the same time.
Size: Create waves by reducing and expanding the
image. This mode allows waves to be created in
one direction only.
Size not modulated.
1 and 2 are the same
size.
Before modulation
Create waves by reducing
1 and expanding 2.
2
Set the following parameters, according to the selected
mode.
When H&V is selected
Parameter group [1/2]
No. Parameter Adjustment
1 Amp H
Amplitude of waves in horizontal
direction
2 Freq H Frequency of waves in horizontal
direction
a)
Offset H
3 Horizontal direction in which to
offset wave phase and amount of
movement
b)
Speed H
4 Horizontal direction and speed of
waves
Parameter group [1/2]
No. Parameter Adjustment
5 Slant Slant of waves
Parameter group [2/2]
No. Parameter Adjustment
1 Amp V Amplitude of waves in vertical
direction
2 Freq V Frequency of waves in vertical
direction
a)
Offset V
3 Vertical direction in which to
offset wave phase and amount of
movement
b)
4 Speed V
Vertical direction and speed of
waves
5 Slant Slant of waves
a) Set when Lock is on.
b) Set when Lock is off.
When Size is selected
No. Parameter Adjustment
1 Amp H Amplitude of waves
2 Freq H Frequency of waves
a)
Offset H
3 Direction in which to offset wave
phase and amount of movement
b)
Speed H
4 Direction and speed of waves
5 Slant Slant of waves
a) Set when Lock is on.
b) Set when Lock is off.
Offset
Amp
To stop the waves
Press [Lock], turning it on.
With each press, the waves alternately stop and start
moving again.
To select the waveform
Press [Form] and set the following parameters.
When H&V mode is selected
No. Parameter Adjustment
1 Form H Waveform in horizontal direction
2 Form V Waveform in vertical direction
Applying Special Effects (Nonlinear Effect Settings)
191