Sony MVS-6520 User Manual page 442

Icon Message
File Open Status
ERROR (01)
ERROR (02)
ERROR (FF): No target device has
been assigned
GPI Input
Please set Target.
Please set Trigger Type.
Please set Reg No.
Please set Aux Bus No.
Please set Src No.
GPI Output
Please set Target.
Please set Trigger Type.
Please set Reg No.
Please set Pulse Width.
Please set Pulse Timing.
HDD Format
No external HDD was found (–2).
Format operation failed (–11).
Cannot access the partition (–12).
Cannot access the directory (–20).
The external HDD is busy (–22).
Import
Cannot create the clip file, because
the number of selected files is
insufficient.
Install
An error occurred during the install
process.
For more details, see Page 9900.
Not Found.
The software package does not exist
on the removable disk.
No Task.
Select a package on the list.
440
Error Messages
Description
533X: Device >DDR/VTR
An error was returned from the DDR/VTR, and one of the messages on the
left appears, depending on the error number.
Use menu 7355 (Engineering Setup >DCU >Serial Port Assign), menu
7325.4 (Engineering Setup >Panel >Device Interface >Device Assign), or
menu 7325.5 (Engineering Setup >Panel >Device Interface >Serial Port
Assign) to check the device settings.
7325.1/2: Engineering Setup >Panel >Device Interface >GPI Input
7337.2/3: Engineering Setup >Switcher >Device Interface >GPI Input
7344.1/2: Engineering Setup >DME >Device Interface >DME1 GPI Input
7344.4/5: Engineering Setup >DME >Device Interface >DME2 GPI Input
7352/7352.1: Engineering Setup >DCU >GPI Input Assign
An incorrect parameter setting value was specified. Check the settings, and
try again.
7325.3: Engineering Setup >Panel >Device Interface >GPI Output
7337.4: Engineering Setup >Switcher >Device Interface >GPI Output
7344.6: Engineering Setup >DME >Device Interface >DME2 GPI Output
7354: Engineering Setup >DCU >GPI Output Assign
An incorrect parameter setting value was specified. Check the settings, and
try again.
2561: Frame Memory >External Device >Ext HDD Format
When [5 Partition] or [15 Partition] was pressed, the external HDD could not
be found. Check that the external HDD is correctly connected.
2561: Frame Memory >External Device >Ext HDD Format
When [5 Partition] or [15 Partition] was pressed, formatting of the HDD
failed.
2561: Frame Memory >External Device >Ext HDD Format
When [5 Partition] or [15 Partition] was pressed, the external HDD logical
drive could not be accessed. Check that the external HDD is correctly
formatted.
2561: Frame Memory >External Device >Ext HDD Format
When [5 Partition] or [15 Partition] was pressed, the external HDD directory
could not be accessed.
2561: Frame Memory >External Device >Ext HDD Format
When [5 Partition] or [15 Partition] was pressed, the external HDD was in
use and could not be accessed. Check that the access lamp of the HDD or
the menu indicator is turned off, and try again.
7162: File >All, External File >Import/Export
When importing a clip file, insufficient files were selected to create the clip.
7316.10: Engineering Setup >System >Install/Unit Config >Install
The menu software installation package does not match the model on which
it is to be installed.
7316.10: Engineering Setup >System >Install/Unit Config >Install
The software package to be installed could not be found. Check that the
removable disk is correctly inserted, and try the installation once more.
7316.10: Engineering Setup >System >Install/Unit Config >Install
The package for installation was not selected. Select a package to be
installed.