Flexi Pad - Sony MVS-6520 User Manual

When the VTR/disk recorder/frame memory
operation mode is enabled
Turning the Z-ring controls the tape transport/disk drive/
frame memory clip operations, at a speed determined by
the operating buttons. Turn clockwise for the normal
direction, and counterclockwise for the reverse direction.
When the resizer operation mode is enabled
By turning the ring, you can zoom the key to which the
resizer is applied, and change the aspect ratio and
perspective.

Flexi Pad

The Flexi Pad is used for creating and recalling snapshots,
wipe snapshots, DME wipe snapshots, key snapshots,
1 Mode selection
buttons
2 EDIT ENBL button
3 Region selection
buttons
5 Memory recall section
a Mode selection buttons
These select the mode.
Name Description
EFF (effect) Press this to carry out effect creation/
recall/editing/execution/deletion.
SNAPSHOT Press this to carry out snapshot creation/
recall/editing/deletion.
SHOTBOX Press this to carry out shotbox creation/
recall/editing/execution/deletion.
MCRO (macro) Press this to carry out macro creation/
editing/execution/deletion.
WIPE (wipe Press this to carry out wipe snapshot
snapshot) creation/recall/deletion and wipe
adjustments.
DME WIPE
Press this to carry out DME wipe
(DME wipe snapshot creation/recall/deletion and
snapshot) DME wipe adjustments.
40
Names and Functions of Parts of the Control Panel
When the [LOC SIZE], [LOC XYZ], or [ASP PERS]
button is held down, the operation is switched to a finer
control (fine mode).
e MENU button
This enables adjustment of the menu parameters using the
trackball and Z-ring.
In the case of the DME menu, the operation applies to the
selected DME channel.
Pressing this button and turning it on in VTR/disk
recorder/frame memory operation mode makes it possible
to carry out timeline start/stop point setting operation for
the selected device (timeline setting mode).
effects, shotboxes, and macros, for setting the transition
rate, and for adjusting keys.
4 Alphanumeric display
Name Description
TRANS RATE
Press this to set the transition rate.
(transition rate)
KEY ADJ (key Press this to carry out key adjustments
adjust) and set modifiers.
KEY SS (key Press this to carry out key snapshot
snapshot) creation/recall/deletion.
By default, this is not assigned to a mode
selection button, so you must assign it to
a mode selection button in the Setup
menu before use.
7 Adjustment knobs
6 Adjustment
knob displays