Sony MVS-6520 User Manual page 137

Current position
(red bar)
Playback start point
(pale blue bar)
Playback end point
(yellow bar)
2
When [Pair] is off, press a target FM selection button
to select the target.
3
To set loop playback, press [Loop], turning it on.
4
Press [Play].
To stop playback, press [Stop].
To cue up
Press [Cue].
To play the image at the beginning of the clip
(Clip Begin)
Press [Rewind].
To play the image at the end of the clip (Clip End)
Press [FF].
To specify the playback start point
To set the current position as the playback start point, press
[Set] in the <Start TC> group. To set to any position, press
the [Start] status button, and enter a timecode value from
the numeric keypad window.
To specify the playback stop point
Start playback, press [Stop] to stop playback at the desired
position, then press [Set] in the <Stop TC> group. To set
to any position, press the [Stop] status button, and enter a
timecode value from the numeric keypad window.
To change the current position
Press the [Current] status button, and enter a timecode
value from the numeric keypad window.
Status buttons
These show the timecode
values for the start point,
current position, and end point.
To delete the parts of a clip file other than the
playback part (trimming)
1
Set the playback start point and stop point.
2
Press [Trim].
3
Check the message, then press [Yes].
Using the device control block to play back
clips
Notes
A frame memory clip must first be recalled with a menu
operation.
1
Press the [DEV] button, and select the frame memory
clip for playback (FM1 CLIP to FM8 CLIP).
If the pair mode is on, both main and subsidiary FMs
light.
2
Press the [PLAY] button, turning it on.
To stop playback, press [STOP] or any of the [SHTL],
[JOG], [CUE], [REW], [FF], and [ALL STOP]
buttons.
For details about the buttons in the device control block,
1 "Device Control Block" (p. 38)
when the VTR/disk recorder/frame memory operation
mode is enabled" (p.
230).
To specify the playback start point
To make the current position the playback start point, press
the [START TC] button.
To specify the playback stop point
Start playback, press the [STOP] button to stop playback
at the desired position, then press the [STOP TC] button.
To apply a loop to a frame memory clip
Press the [FM LOOP] button.
To carry out the variable speed playback
Press any of the [SHTL], [JOG], and [VAR] buttons, then
turn the Z-ring. The image changes in the forward
direction when you turn the Z-ring clockwise, and in the
reverse direction when you turn it counterclockwise.
When you pressed the [JOG] button: Playback is at a
speed corresponding to the turning speed of the Z-ring.
When you pressed the [SHTL] button: Playback is at a
speed corresponding to the rotation angle of the Z-
ring.
When you pressed the [VAR] button: Playback is at a
speed corresponding to the rotation angle of the Z-
ring, in the range –1 to +3 times normal speed.
1 "Buttons used
and
Frame Memory Clip Operations
137