Sony MVS-6520 User Manual page 140

Setting a clip transition
This section describes a clip transition using FM1&2 Clip
on the M/E-1 bank as an example.
Notes
To use a clip transition effectively, the image from the
frame memory clip being played back during the clip
transition should be applied to the M/E-1 program output.
For example, inserting a key using frame memory output 1
and frame memory output 2.
1
In the M/E-1 >Misc >Transition menu (1171), and
select [FM1&2 Clip] in the <Transition Type> group.
2
Press [Clip Transition].
The Clip Transition menu (1176) appears.
Background transition
display area
Clip display area
3
Press [Clip].
The status area shows a list of clips.
4
Select the clip to use in the clip transition.
5
Return to the Clip Transition menu, and in the <BKGD
Transition Type> group, select the background
transition type.
Notes
For details about the background transition selected
here, see the various adjustments in the M/E-1 >Misc
>Transition menu.
6
In the <Select> group, press [BKGD Transition].
140
Clip Transition Operations
Clip transition
display area
7
Use either of the following methods to set the
background transition start point independently of the
clip playback timing.
• Move the fader lever to the desired position, and in
the <BKGD Transition Set Timing> group, press
[Start].
• Set the number of frames in the [BKGD Trans Start]
parameter. (The left end of the reference axis (see
following figure) is the position of frame 0.)
Position of frame 0
8
Using either of the following methods, set the end
point of the background transition.
• Move the fader lever to the desired position, and in
the <BKGD Transition Set Timing> group, press
[Stop].
• Set the number of frames in the [BKGD Trans Stop]
parameter.
9
If [Wipe] or [DME Wipe] is selected in the <BKGD
Transition Type> group, in the <BKGD Transition
Direction> group, select the background transition
direction.
10
In the <Select> group, press [FM1&2 Clip].
11
Using either of the following methods, set the start
point of the clip.
• Move the fader lever to the desired start point, and in
the <Clip Transition Set Timing> group, press
[Start].
• Set the number of frames in the [Clip Start]
parameter. (The left end of the reference axis (see
previous figure) is the position of frame 0.)
Notes
It is not possible to set the clip end point.
12
In the <Clip Transition Direction> group, select the
playback direction of the clip.
To reset the start point and end point
Press [Timing Reset].
The background transition start point and end point, and
the clip start point are all reset.
Reference axis