Setting The Run Mode; Executing An Effect In The Flexi Pad Control Block - Sony MVS-8000X User Manual

Executing an effect manually
In step 3 above, operate the fader lever.
To use the transition control block fader lever as
a keyframe fader
Press the [KF] button in the transition control block,
turning it on, to execute a keyframe effect with the fader
lever in the same control block.
You can also assign the [KF] button to a transition type
selection button in the transition control block (see page
167).
Notes
• It is not possible for the [KF] button to be on for multiple
banks (M/E or PGM/PST) at the same time. If you press
the [KF] button in more than one bank, only the last
button pressed remains on.
• If a macro is assigned to the transition control block
fader lever, then while in use as a keyframe fader the
macro is not executed.
Moving to the first keyframe of the effect
To move to the first keyframe of the effect, press the
[REWIND] button.
Moving to the last keyframe of the effect
To move to the last keyframe of the effect, press the [FF]
button.

Setting the Run Mode

You can set the run mode in which an effect is executed
when you press the [RUN] button.
Specifying the effect execution direction
To specify the effect execution direction, press the
[NORM] button or the [REV] button, turning it on. When
you press one, turning it on, the other automatically goes
off.
To execute the effect so as to obtain the effects of the
[NORM] and [REV] buttons alternately, press the
[NORM/REV] button, turning it on.
When the [NORM] button is lit: The effect is executed
in the direction from the first keyframe to the last
keyframe.
When the [REV] button is lit: The effect is executed in
the direction from the last keyframe to the first
keyframe.
When the [NORM/REV] button is lit: Each time the
effect is executed, the direction reverses.
Executing an effect up to the next
keyframe
1
Press the [STOP NEXT KF] button, turning it on.
2
Press the [RUN] button.
This executes the effect as far as the next keyframe.
When the [REV] button is lit, it is executed as far as
the previous keyframe.
Repeating an effect
1
Press the [EFF LOOP] button, turning it on.
2
Press the [RUN] button.
This executes the effect repeatedly, from the first
keyframe to the last keyframe.
When the [REV] button is lit, the effect is executed in
the reverse direction.
3
To stop the repeating effect, press the [EFF LOOP]
button, turning it off, or press the [REWIND] button.
Executing an Effect in the Flexi Pad
Control Block
Executing an effect
To execute an effect recalled from the numeric keypad
control block in the Flexi Pad control block, use the
following procedure.
1
In the Flexi Pad control block, press the [EFF] button.
This assigns the Flexi Pad control block to effect
operation, and the [REWIND] button and [RUN]
button appear in the memory recall section.
The previously selected bank number and last recalled
register number appear in the numeric display.
2
Press the following buttons to execute the effect.
REWIND: Press this button to move to the first
keyframe of the currently recalled effect.
RUN: Press this button to run the currently recalled
effect.
57
Executing Effects