Setting Independent Key Transition Wipe Modifiers - Sony MVS-6520 User Manual

Independent Key Transition Wipe
Pattern Selection
1
In the Key1 Wipe Adjust menu, select [Pattern Select].
The Pattern Select menu (1116.2) appears.
2
Press the button to select the desired pattern.
Setting Independent Key Transition
Wipe Modifiers
Available modifiers
You can use the following modifiers with an independent
key transition wipe.
However, the available modifiers may depend on the
pattern you are using.
• Direction
• Soft edge
• Positioner
• Rotation
• Aspect ratio
• Multiplication
Setting the wipe direction (Direction)
In the <Direction> group of the Key1 Wipe Adjust menu,
make one of the following selections.
Normal: Regular direction
Normal/Reverse: Alternate between regular and reverse
for each transition
Reverse: Opposite direction of normal
Softening the wipe pattern edge (Soft
edge)
1
In the Key1 Wipe Adjust menu, press [Soft], turning it
on.
2
Set the following parameter.
No. Parameter
1 Soft
Setting the wipe position (Positioner)
There are two methods of setting the wipe position: using
the device control block, or in a menu.
To set the wipe position using the trackball
1
Press the [M/E1] button in the device control block,
turning it on.
106
Basic Wipe Setting Operations for Independent Key Transitions
Adjustment
Edge softness
The buttons in the device control block are assigned to
the wipe position setting as follows.
Table 1: Buttons and assigned settings
Setting
Button
name
K1 Wipe position for independent key 1
transition
K2 Wipe position for independent key 2
transition
K3 Wipe position for independent key 3
transition
K4 Wipe position for independent key 4
transition
Table 2: Buttons assigned to functions
Function
Button
name
POS Toggle Position On/Off.
X, Y Fix the operating direction.
CTR Return the pattern position to the center of
the screen.
2
Press the [K1] button, and select the setting item (key
1).
Notes
You can also enable simultaneous selection of
multiple keys in the Setup menu.
3
Press the [POS] button, turning Position on.
4
Move the trackball to set the wipe position.
By pressing the [X] button, turning it on, you can
restrict movement to the horizontal direction, and by
pressing the [Y] button, turning it on, you can restrict
movement to the vertical direction.
To set the wipe position by a menu operation
1
In the Key1 Wipe Adjust menu, press [Position],
turning it on.
2
Set the following parameters.
No. Parameter Adjustment
1 Position H Horizontal position
Vertical position
2 Position V
1 p.
a) 103.
To move the pattern from its current position to
the center through the course of a transition
Press [Auto Center], turning it on.
a)
a)