Applying Special Effects; Settings); Wave Settings - Sony XKS-C9111 User Manual

Applying Special Effects

(Nonlinear Effect

Settings)

You can add a variety of effects that change the shape of
the image as a whole as nonlinear effects.
Non-Linear effect setting menu
1
Open the DME >Non Linear/Corner Pin >Non Linear
menu (4141).
2
Press a button for the desired effect to select it and
open the setting menu.
3
Configure settings for the selected effect.
Notes
• It is not possible to apply two or more nonlinear effects
at the same time. Enabling an effect automatically
disables the previously enabled effect.
• The Flex Shadow function cannot be enabled when the
Page Turn, Roll, Cylinder, or Sphere nonlinear effect is
enabled.
• There may be differences in the nonlinear effects
depending on the board used (XKS-8470 or XKS-8475).
To disable an effect
Press the button for the effect name, turning it off, in the
corresponding effect setting menu.
Or, in the Non Linear menu (4141), press [OFF] in the
lower right of the display.

Wave Settings

There are two modes: H&V and Size. You can set the size
and frequency of the waves, the waveform, the amount of
wave movement, and the range. In H&V mode, you can
also set the wave angle.
Applying the Wave effect
1
In the <Mode> group of the Non Linear >Wave menu
(4141.1), select the wave modulation mode.
H&V: Modulate vertically and horizontally without
changing the size of the image. This mode allows
waves to be created in both the vertical and
horizontal directions at the same time.
Size: Create waves by reducing and expanding the
image. This mode allows waves to be created in
one direction only.
Modulation is not applied to Size.
1 and 2 are same size.
Before modulation
Create waves by reducing 1
and expanding 2 the image.
2
Set the following parameters, according to the selected
modulation mode.
When [H&V] is selected
No. Parameter Adjustment
1 Amp H
2 Freq H
3 Offset H
4 Speed H
5 Slant
No. Parameter Adjustment
1 Amp V
2 Freq V
3 Offset V
4 Speed V
5 Slant
249
Parameter group [1/2]
Amplitude of wave in horizontal
direction
Frequency of wave in horizontal
direction
a)
Phase shift direction and offset of
wave in horizontal direction
b)
Direction of travel and speed of
wave in horizontal direction
Slant of wave
Parameter group [2/2]
Amplitude of wave in vertical
direction
Frequency of wave in vertical
direction
a)
Phase shift direction and offset of
wave in vertical direction
b)
Direction of travel and speed of
wave in vertical direction
Slant of wave