Veikong gpd 515/g5 Startup Manual page 97

5.7 AUTOMATIC SPEED REGULATOR (ASR)
B . C 5 - 0 3 : ASR Proportional Gain 2
(ASRP2)
C 5 - 0 4 : ASR Integral Time 2
(ASRI2)
Parameter C 5 - 0 3 is used as an additional proportional gain adjustment, and parameter
C 5 - 0 4 determines the response time for Proportional Gain 2 ( C 5 - 0 3 ) .
GAIN
C . H 1 - 0 1 thru H 1 - 0 6: Multi-function
Input Terminal Function
Selection (Term. 3 thru 8)
By programming data " E " into one of the
multi-function input parameters ( H 1 - 0 1 thru
H 1 - 0 6 ), one of the multi-function input terminals
(3 thru 8) becomes an ASR integral reset. When
there is a long time lag between the applying of
control power and actual run operation, output
voltage may be produced due to the integrator
offset. In such cases, the integral reset function
should be ON until the start of run operation.
D . C 5 - 0 6 : ASR Output Lag Time
This function is used as a filter for mechanical problems such as mechanical backlash, play,
etc., which may prevent the ASR proportional gain from being increased as adjusted.
C5-03
0
C5-07
Continued
Factory setting: 2 0 . 0 0
Range: 0.00 to 300.00
Factory setting: 0 . 5 0 0
Range: 0.000 to 10.000 seconds
C5-01
SPEED
Data E: ASR Integral Reset (IRST)
ASR
I-RESET
o
Factory setting: 4
Range: 0 to 500 msec
5-11
GPD 515/G5
8
o
11
0V