Veikong gpd 515/g5 Startup Manual page 77

Table 4-1. Digital Operator Controls - Continued
NAME
LABEL
MENU IN DRIVE MODE: Pressing this key will display the top level of the menu tree for
selecting and reading parameters. The drive will change to Program mode.
IN PROGRAM MODE: Pressing this key will display the top level of the menu tree
for returning to the Drive mode. Pressing the MENU & DATA/ENTER keys in
succession will change to Drive mode and display the frequency reference setting.
ESC Each time this key is pressed the display returns to the previous level in the menu
tree or to the status prior to pressing DATA/ENTER.
DATA IN DRIVE MODE OR PROGRAM MODE: When a parameter number is being
ENTER displayed, pressing this key will display the parameter's set value which is
presently in memory.
IN PROGRAM MODE ONLY: After the displayed set value has been changed as
desired, pressing this key will write the new set value into the drive memory to
replace the old value.
>
IN DRIVE MODE OR PROGRAM MODE: When a changeable data value is being
RESET displayed, pressing this key moves the blinking (i.e. "changeable") position to the
next digit to the right. If at the right-most position, this will wrap-around to the first
position on the left side of the display.
^ IN DRIVE MODE OR PROGRAM MODE: Pressing this key will increase the value
(up arrow) of the blinking digit in the display by 1. Pressing this key will increase a parameter
number by 1.
v
IN DRIVE MODE OR PROGRAM MODE: Pressing this key will decrease the value
(down arrow) of the blinking digit in the display by 1. Pressing this key will decrease a parameter
number by 1.
POWER
ON
RUN
COMMAND
FREQUENCY
REFERENCE
OUTPUT
FREQUENCY
RUN
LAMP
STOP
LAMP
Figure 4-2. Functioning of RUN and STOP Lamps
B. KEYPAD KEYS – Continued
B. KEYPAD PADS – Continued
FUNCTION
FUNCTION
PRESS
RUN KEY
= Off
4-3
PRESS
STOP KEY
= Blinking = Lighted Steady