Veikong gpd 515/g5 Startup Manual page 195

5 . 4 8 V / f P A T T E R N - C U S T O M
NOTE: To establish a V/f pattern with a straight line from Fmin to Fbase, set
F = Fmin, F
A B
are then disregarded and do not affect the V/f pattern.
The parameter settings are checked whenever power is applied to
the drive, or each time the ENTER key is pressed while in the
Program mode. A parameter set value failure ( OPE5 ) will occur if
any part of the following relationship among E 1 - 0 4 thru E 1 - 1 3
is not TRUE:
Fmax ≥ F
= 0.0 Hz, and Vbase = 0.0 V. The settings of V
≥ Fbase ≥ F
B
Continued
IMPORTANT
≥ Fmin (unless F
A
5-109
, V and Vbase
A B
or F = 0.0)
A B