Local Remote And Reference Selection - Veikong gpd 515/g5 Startup Manual

5.25 LOCAL/REMOTE AND REFERENCE SELECTION
d 1 - 0 1 : Memory 1
d 1 - 0 2 : Memory 2
d 1 - 0 3 : Memory 3
d 1 - 0 4 : Memory 4
d 1 - 0 5 : Memory 5
H 3 - 0 5 : Multi-function Analog Input (Term. 16) (See paragraph 5.30)
b 1 - 0 2 : Operation Method Selection
H 1 - 0 3 thru H 1 - 0 6 : Multi-function Input Terminals; data " 3 ", " 4 ", " 5 ", and
" 6 " [ or " C " ], respectively, for Reference Select 1, 2, 3 and Jog [ or
Multi-function Analog Input at Term. 16 ] (See paragraph 5.31).
For Local/Remote select, see paragraph 5.31, data " 1 " description.
b 1 - 0 1 : Reference Selection (See below, or separate Option Instruction Sheet).
The drive allows selection of one of twelve references. Two are analog inputs, nine are
stored in memory, and one can be from an option card, either analog or digital. In most
configurations either the local reference ( d 1 - 0 1 ) or the remote AUTO reference will be
utilized.
The range and resolution of the d 1 - X X parameters is dependent on
the setting of o 1 - 0 3 (see paragraph 5.11).
5 . 2 5 A L o c a l / R e m o t e R e f e r e n c e S e l e c t i o n
b 1 - 0 1 : Reference Selection
By programming b 1 - 0 1 = 1, the external Auto reference input will be used. If b 1 - 0 1 is
programmed to " 0 ", the value in d 1 - 0 1 will be used as a frequency command.
d 1 - 0 1 will change each time the operator enters a new frequency command
from the Digital Operator's " U 1 - 0 1 = X X . X X " prompt. Another way to
think of this is that when the drive is first powered up, the Digital
Operator displays " F r e q u e n c y R e f e r e n c e
value displayed is the current setting of d 1 - 0 1 . If the operator changes
the display, then d 1 - 0 1 will also be changed.
d 1 - 0 6 : Memory 6
d 1 - 0 7 : Memory 7
d 1 - 0 8 : Memory 8
d 1 - 0 9 : Jog Reference
(See paragraph 5.24)
NOTE
Data: 0 = Local (Digital Operator) frequency
IMPORTANT
5-39
Factory setting:
d 1 - 0 1 thru d 1 - 0 8 : 0 . 0 0
Range (all): 0.00 to 400.00 Hz
reference
1 = Remote (terminals) frequency
reference
U 1 - 0 1 = X X . X X H Z ". The
d 1 - 0 9 : 6 . 0 0