Veikong gpd 515/g5 Startup Manual page 285

INSTALLATION
This option should only be installed by a TECHNICALLY QUALIFIED INDIVIDUAL who is
familiar with this type of equipment and the hazards involved.
Hazardous voltage can cause severe injury or death. Lock all power
sources feeding the drive in the "OFF" position.
Failure to follow these installation steps may cause equipment damage or
personnel injury.
Preliminary Procedures
1 . Disconnect all electrical power to the
drive.
2 . Remove drive front cover.
3 . Use a voltmeter to verify that voltage
is disconnected from incoming power
terminals.
Heat Sink Mount Resistor Installation
1 . Remove the drive from its mounting for
access to the rear of the heat sink.
2 . Attach the Heat Sink Mount Resistor on
the back of the drive's heat sink, as
shown in Figure A6-1.
3 . Reinstall the drive in its mounting
position.
4 . Connect the leads from the Heat Sink
Mount Resistor to drive terminals
according to Figure A6-2.
5 . Proceed to "ADJUSTMENTS" on page
A6-7.
WARNING
CAUTION
HEAT SINK
MOUNT
RESISTOR
Figure A6-1. Attaching Heat Sink Mount Resistor
B1
Figure A6-2. Lead Connections For Heat Sink
A6-3
on Heat Sink
GPD 515/G5
B2
P
B
HEAT SINK MOUNT
RESISTOR
Mount Resistor