F3-01 - Veikong gpd 515/g5 Startup Manual

Table 1-3. Terminal Functions and Signals of Control Circuit - Continued
TERMINAL FUNCTIONS
TERMINAL FUNCTIONS
21 Multi-function analog monitor 1 (+)
22 Multi-function analog monitor (–)
23 Multi-function analog monitor 2 (+)
25 Multi-function open collector
output 1
26 Multi-function open collector
output 2
27 Multi-function open collector output common
33 Frequency reference power supply
NOTES:
1 . When Forward Run and Reverse Run inputs are both closed for more than 500 ms, the Digital
Operator displays a blinking " EF " alarm code and the motor (if rotating) is decelerated by the
drive to a stop. This stop condition is not stored by the drive (on Digital Operator, red LED at
S T O P key does not light); IF ONE OF THE INPUTS IS OPENED, THE MOTOR WILL
I M M E D I A T E L Y S T A R T U P A G A I N .
2 . Terminals 1-8 source +24 Vdc (8mA max.) and operate in a Low = True (ON) configuration when
connected to terminal 11.
When using relays for input to terminals 1-8, use relays with highly reliable contacts (for very
small current) with a capacity of 30 Vdc or more and rated current of 100mA or higher. When
using transistor (open collector) input, use transistors with rated voltage of 35 Vdc or more and
rated current of 100mA or more.
3 . These terminals are multi-function inputs. The indicated functions are their settings, based on a
2-Wire reset. For 3-Wire reset definitions, and other settings, see descriptions for "Multi-
Function Input Terminals", parameters H 1 - 0 1 t h r u H 1 - 0 6 , in paragraph 5.32.
LEVELS
DESCRIPTION / SIGNAL LEVELS
Output current Type of analog signal (operation parameter) to be
or output output is selected by setting of parameters H4-01
frequency is and H4-04 .
selectable Monitor output: 0 to +11V; 2 mA maximum
One of 18 functions Photocoupler insulation output: +48V, 50 mA
available, by setting maximum
of parameters H2-02
and H2-03 .
0V
–15V Control power supply for frequency setting:
max 20 mA
1-18