Veikong gpd 515/g5 Startup Manual page 204

T a b l e 6 - 1 . F a u l t I n d i c a t i o n a n d D e t a i l s – C o n t i n u e d
DIGITAL OPERATOR
DISPLAY
CPF02
BB Circuit Failure
CPF03
EPROM Error
CPF04
Internal A/D Err
CPF05
External A/D Err
CPF06
Option Error
CPF20
Option A/D Error
CPF21
Option CPU down
CPF22
Option Type Err
CPF23
Option DPRAM Err
DEV
Speed Deviation
E - 15
SI - F/G Com Err
EF
External Fault
EF0
Opt External Flt
EF3
External Fault 3
EF4
External Fault 4
DESCRIPTION
Baseblock circuit fault
EPROM fault
Internal A/D fault
External A/D fault
Option card
connection failure
A/D converter fault in
Analog Speed
Reference card
Communication option card
self-diagnostic error.
Communication option card
Model code error.
Communication option card
DPRAM error.
Speed deviation
SI - F/G Communications
Error
Both FWD and REV
commands were applied
simultaneously
External fault input from
Communication option card.
External fault signal at
terminal 3
External fault signal at
terminal 4
DETAILS
Drive failure.
(Note 3)
Replace Control card.
Check option card connection.
Option card failure.
(Note 3)
Option card (AI-14B) A/D converter malfunction.
(Note 3)
Communication option card failure.
Deviation between speed reference and speed
feedback exceeded the deviation level ( F1-10
& F1-11 ). Stop mode selection possible ( F1-04 ).
A communications error occurred and b1-01=3
and/or b1-02=3.
Drive is in "temporary" Ramp to Stop condition; one
input command must be removed to resume
operation.
Check communication option card connection and
signal.
A fault condition has occurred in the external
circuit(s) monitored by the contact providing input to
the indicated terminal.
Stop mode selection possible ( H1-01 thru H1-06 ).
(See Section 5.17)
(Note 3)
6-2
TYPE
(Note 1)
M
M
M
M
m
(Note2)
M
(Note2)
m
M
(Note 2)
M
(Note 2)