Veikong gpd 515/g5 Startup Manual page 16

Do not touch circuit components until main input power has been turned off and
"CHARGE" lamp is extinguished. The capacitors are still charged and can be quite
dangerous.
Do not connect or disconnect wires and connectors while power is applied to the
circuit.
Know your application before using either Initialization function of A1-03 . This
parameter must be set to " 0 " for Drive mode operation.
" 1110 " = User Default Parameter Initialization
" 2220 " = Factory 2-Wire Control Initialization (Maintained RUN Contact)
" 3330 " = Factory 3-Wire Control Initialization (Momentary START/STOP
Entering any Initialization code resets all parameters, and automatically returns
A1-03 setting to " 0 ". If the GPD 515 is connected for 3-Wire control and this param-
eter is set to " 2220 " (2-Wire Control Initialization), the motor may run in reverse
direction WITHOUT A RUN COMMAND APPLIED. Equipment damage or personal
injury may result.
When drive is programmed for auto-restart ( L5-02 = " 1 " thru " 10 "), the motor may
restart unexpectedly — personal injury may result.
Data subject to change without notice.
Contact)
WARNING
CAUTION
CAUTION
xviii