Veikong gpd 515/g5 Startup Manual page 260

T a b l e A 1 - 9 . D r i v e o X - X X P a r a m e t e r s – C o n t i n u e d
PARAMETER F U N C T I O N
NUMBER N A M E
o2-08 Elapsed
Operating
Hour Timer
Selection
o2-09 Initial Mode
Selection
NOTES:
1 . Not initialized. Factory setting differs depending on the drive capacity.
2 . Capability to view and set specific parameters is dependent upon the Access Level
( A 1 - 0 1 ) and Control Method ( A 1 - 0 2; 0 = V/f, 1 = V/f w/PG, 2 = Open Loop
Vector, 3 = Flux Vector) the drive is programmed for. Each column represents the
Access Level for a given Control Method: Q = Quick-start; B = Basic; A = Advanced;
— = not available.
D E S C R I P T I O N
0 : Timer active whenever
power is applied to drive
1 : Timer active whenever
drive is in "run" mode
0 : Japanese Spec.
1 : American Spec.
2 : European Spec.
INCRE- S E T T I N G
M E N T RANGE
1 0, 1
1 0 - 2
A1-26
A C C E S S L E V E L
F A C T O R Y
( S e e N o t e 2 )
S E T T I N G
0 1 2
0 A A A A
1 A A A A
P A R A .
REF .
3
5.26