Digital Operator; General; Display And Keypad - Veikong gpd 515/g5 Startup Manual

Section 4.
4.1

GENERAL

All functions of the GPD 515/G5 are accessed using the Digital Operator. In addition to
controlling motor operation, the operator can enter information into the drive memory to
configure the drive to the application by entering the Program mode.
4 . 2 D I S P L A Y A N D KEYPAD
The Digital Operator has a 2 line by 16 character LCD display. Both numeric and alpha-
numeric data can appear on the display.
Indicator lamps and keys on the Digital Operator are described in Figure 4-1.
REMOTE Mode indication LEDs.
The LEDs light when REMOTE
Mode has been selected,
either for Start/Stop (SEQ)
control or Frequency
Reference (REF).
Indicates which direction
the motor is being
commanded to run.
Lights when the GPD 515/G5
is in Drive (operation) mode.
Increase parameter number
or value of blinking digit.
Switch between LOCAL and
REMOTE operation modes.
Initiates Jog function.
Selects forward or
reverse operation.
Run the motor. LED lights
when drive is controlling
motor speed.

DIGITAL OPERATOR

DRIVE FWD REV
SEQ
Frequency Ref
U1-01 = 0.00 Hz
DIGITAL OPERATOR
JVOP-130
LOCAL
MENU
REMOTE
JOG
FWD
REV
RUN
F i g u r e 4 - 1 . D i g i t a l O p e r a t o r
4-1
REMOTE
REF
ESC
DATA
ENTER
RESET
STOP
2 line, 16 character
alphanumeric LCD display;
shows selected operation
status, fault code, or
parameter data.
Displays the main menu for
mode selection.
Returns to previous status
or menu level.
Displays data to be
changed, and enters new
data.
Decrease parameter number
or value of blinking digit.
Resets a drive fault, or
selects digit of a set value to
be changed. The selected
digit will blink.
Stop the motor. LED lights
when drive is in stopped
condition.