Monitoring The Running Status Of An Acl; Configuration Examples; Example For Configuring A Basic Acl; Example For Configuring The Blacklist And Whitelist - Huawei Quidway S9300 Configuration Manual

8 ACL Configuration
Context
Statistics cannot be restored after being cleared. So, confirm the action before you run the
command.
Procedure
l
l
----End

8.5.3 Monitoring the Running Status of an ACL

Context
During routine maintenance, you can monitor the running status of an ACL by running the
following commands.
Procedure
l
l
l
----End

8.6 Configuration Examples

This section provides configuration examples of the ACL.

8.6.1 Example for Configuring a Basic ACL

8.6.2 Example for Configuring an Advanced ACL
8.6.3 Example for Configuring a Frame Header-based ACL

8.6.4 Example for Configuring the Blacklist and Whitelist

8.6.1 Example for Configuring a Basic ACL
Networking Requirements
As shown in
connected to the upstream router. To prevent source address spoofing, you need to configure
8-12
CAUTION
Run the reset blacklist command in the user view or system view to clear the statistics
about a blacklist.
Run the reset whitelist command in the user view or system view to clear the statistics
about a whitelist.
Run the display acl { acl-number | all } command to view the configured ACL.
Run the display time-range { all | time-name } command to view the time range.
Run the display acl resource [ slot slot-number ] command to view information about
ACL resources.
Figure 8-1, GE 1/0/1 of the S9300 is connected to the user, and GE 2/0/1 is
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Security
Issue 01 (2009-07-28)