Installing The Unit (Kx-Td290) - Panasonic KX-TD1232E Installation Manual

7.2.2 Installing the Unit (KX-TD290)

1. Loosen the two the screws on the cover
plate. Insert fingers into the slits to
remove the cover plate.
Slit
Note Any of the cover plates can be
removed, as needed.
2. Connect the cabinet cord to the connec-
tor in the main unit firmly.
The following procedures can be used to install the Primary Rate
Interface (PRI) ISDN Expansion Unit (KX-TD290).
Default KX-TD816: bottom = 4-CO Line Unit,
top = 8-Station Line Unit
KX-TD1232: bottom = 4-CO Line Unit,
Note The KX-TD1232 is illustrated as a main unit.
Slit
middle and top = 8-Station Line Unit
3. Hook the cabinet on the main unit and slide
the cabinet to the left until it is secured.
4. Loosen the outside screw and slide the
cover to the right.
5. Secure the inside screw (included) to
fix the cabinet to the main unit.
Note Be sure to fix the inside screw to the main
unit, or the unit may not work properly.
Outside screw
Inside screw
PRI Section 7-5