Panasonic KX-TD1232E Installation Manual page 710

Site Survey
Assigning a PS ( TD7500 ) to a Cell Station
To enter Survey Mode : Switch PS On while pressing, 'TALK' + 'FLASH (
Step Display : Entry
FUNCTION < 0 – 4 >
[ 0 ] Current Status Displayed
To Survey other slots : Press [ # ] (Next) or [ * ] (Previous)
To Survey other channels : Press [ 0 ~ 9 ]
[ TALK ] To record results
** All Book Data is cleared **
[ CLR ] To return to test result display
[ TALK ] To Clear all Log data, Press ( . )
[ 0 ~ 9 ] Log Number
[ TALK ] Record results
Locating Cell Stations (CS)
• The CS should be located at the point where the signal strength from the nearest CS is at least
'Level 3'.
• If Handover problems occur the signal strength between two adjacent CS could be poor, the CS may
not recognise the adjacent CS and could use the same channel ( 0 ~ 9 ), try relocating the CS closer.
But it is recommended to maintain a minimum distance of 5 metres between CS.
• For a good Handover the cross over should be 'Level 8' from both CS for a minimum of 3 metres.
• If additional speech paths are required in one area additional CS can be located in that area, but a
minimum distance of 5 metres should be maintained between two CS.
• When more than two CS are required to provide additional speech paths in one area only two CS
should be located within the RSSI Level 11 of any CS.
CS CS
Min 5m
.
)' + '
RSSI Level 11
CS
'
*
5