Panasonic KX-TD1232E Installation Manual page 496

7003
Description
Selection
Default
Programming
Conditions
Feature References
4-146.0 System Programming
4.9
Itemized Code Set
Registers an itemized code applied to an extension.
The registered code is inserted into the "I" command position
stored in program [7X22] "LCR Carrier Modify Command."
• Jack number: KX-TD816 – 01 through 16 (-1 / -2)
KX-TD1232 – 01 through 64 (-1 / -2)
(-1 = first part, -2 = second part)
• Itemized code: 4 digits (max.)
KX-TD816: Jack 01-1 through 16-1 = 201 through 216;
Jack 01-2 through 16-2 = 301 through 316
KX-TD1232:Jack 01-1 through 64-1 = 201 through 264;
Jack 01-2 through 64-2 = 301 through 364
1. Enter 7003.
Display: Itemized Code
2. Press NEXT.
Display: Jack NO?–>
3. Enter a jack number.
To enter jack number 01, you can also press NEXT. To select the
second part (-2), press NEXT after entering a jack number.
Display example: #01-1: Not Stored
4. Enter an itemized code.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and the new code.
5. Press STORE.
6. To program another jack, press NEXT or PREV, or
SELECT and the desired jack number.
7. Repeat steps 4 through 6.
8. Press END.
• There is a maximum of 32 itemized codes for KX-TD816, and 128
itemized codes for KX-TD1232. Each code has a maximum of 4 digits,
consisting of 0 through 9.
• In the case of KX-TD1232, jack numbers 01 through 32 are for the
Master System and 33 through 64 are for the Slave, if available.
Section 3, Features,
Least Cost Routing (LCR)
LCR Programming