Panasonic KX-TD1232E Installation Manual page 358

109
Conditions
Feature References
4-48 System Programming
4.3
Expansion Card / Unit Type
3. Keep pressing SELECT until the desired selection is
displayed.
4. Press
5. Keep pressing SELECT until the desired selection is
displayed.
6. Repeat steps 4 and 5 until all the required entries are
completed.
7. Press STORE.
If only one system is in operation, go to step 8.
8. Press NEXT to program Slave System.
Display example: Slav. :C;C;E1;E2
9. Repeat steps 3 and 7.
10. Press END.
• When starting the system for the first time or performing System Data
Clear, the application for location will use practical installation instead
of the system default setting.
• For KX-TD816, there is one expansion area inside the system, area 1,
and there are two expansion areas on the system, area 2 and 3 from
bottom to top.
• For KX-TD1232, there is one expansion area inside the system, area 1,
and there are three expansion areas on the system, area 2, 3 and 4 from
bottom to top.
• If the Slave System of KX-TD1232 is out-of-service, skip the steps 8
and 9.
• After changing the setting, to make your setting effective, turn the
Power Switch off and on again. Otherwise the previous setting will be
maintained.
Section 3, Features,
Module Expansion
System Programming
(contd.)
.