402
Feature References
4-90
System Programming
4.6
CO Line Programming
Dial Mode Selection
• To assign all lines to one selection, press the
case, the display shows the contents programmed for CO01.
• If DTMF is assigned, set the DTMF time of the line in program [404]
"DTMF Time."
• If pulse or call blocking is assigned, set the pulse speed of the line in
program [403] "Pulse Speed Selection," and set the pulse break ratio
and inter-digit pause in program [990] "System Additional Information,
Area 02 – bits 7, 12 and 11," if needed.
Section 3, Features,
Dial Type Selection
(contd.)
key in step 3. In this