Panasonic KX-TD1232E Installation Manual page 702

Installing a KX-TD290 Primary Rate Module (30 channel)
The TD290 is an external module, which supports 30 channels,
Note: Prog Step 109 and ISDN Configuration programming require a system reset to activate
c) Module installation.
• If the Module is fitted and the PBX is defaulted, the card will be assigned on power up.
• If you are adding the Module use Program step 109 to assign,
Assign "S3" to the required Area
Only one CO Module can be assigned to the PBX at the same time. If the CO Module is
assigned to the lower Area the upper Area must be assigned as an Extension "E"
(i.e. C; S3; E1; E2).
d) Port numbering
When the TD290 is fitted to a TD1232 the channels are assigned as
Channel 1 as CO 25 to Channel 30 as CO 54.
ISDN connection configuration
Prog Step
450
451
Installation Hints – ISDN Options
Description
Primary Rate Assignment
Assigns the number of B channels available,
0 Y Y - - Analogue configuration
30 Y - N N 30 "B" Channels Primary Rate allowed
30 N - Y N 30 "B" Channels Primary Rate allowed
30 N - N Y 30 "B" Channels Primary Rate allowed
26 Y - N Y 26 "B" Channels Primary Rate allowed
26 N - Y Y 26 "B" Channels Primary Rate allowed
22 Y - Y N 22 "B" Channels Primary Rate allowed
18 Y - Y Y 18 "B" Channels Primary Rate allowed
Note: An Analogue (TD181) or ISDN2 (TD281) card can be fitted to the
"Y" positions of the PBX.
PRI Reference CO
With the exception of: Trunk Group Assignment [401],
The Primary Rate CO's are not included in I/C and O/G CO Line
programming.
To program channels assign a reference to the desired channels and set the
I/C and O/G programming for that reference CO Line.
Reference CO's 9 to 12 are available.
CO Line Number [419],
CO Line Name [421] &
Single CO Button Assignment [Prog 99 or 005]