Panasonic KX-TD1232E Installation Manual page 663

System Programming
Description
Selection
Default
Programming
Conditions
TIE Outgoing Assignment
Assigns a TIE outgoing method, immediate or wink, to each TIE
table depending on your central office service.
Immediate: Outgoing and TIE numbers can be transmitted right
after seizing the CO line.
Wink: Outgoing and TIE numbers can be transmitted after
receiving the wink signal from the central office after seizing the
CO line.
• TIE table number: 1 to 4,
• Immediate / Wink
All TIE tables – Wink
1. Enter 432.
Display: Signal Out
2. Press NEXT.
Display: Table NO?→
3. Enter a TIE table number.
To enter TIE table number 1, you can also press NEXT.
Display example: 1:Wink
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another TIE table, press NEXT or PREV, or
SELECT and the desired TIE table number.
7. Repeat steps 4 through 6.
8. Press END.
• The time the system waits for the confirmation wink signal can be
programmed in program [435] "TIE Wink Time Out Assignment". The
system disconnects the CO line when the time-out time expires.
• To assign all TIE tables to one selection, press the
this case, the display shows the contents programmed for TIE table
number 1.
( =all TIE tables)
key in step 3. In
432
31