Panasonic KX-TD1232E Installation Manual page 625

8.4 DECT PS System Programming
Description
Selection
Default
Programming
Conditions
Feature References
PS Incoming Call Display
Selects the display type for each PS when an incoming call is
received. You can select the display type from one of the
following:
Caller: The incoming caller's telephone number and name are
displayed.
CO Line: The CO line number and name assigned in the [421]
program are displayed.
DDI: The called party's DDI number and extension name is displayed.
• PS registration number: KX-TD816 – 01 through 16,
• Display Type: Caller / CO Line / DDI
All PSs – Caller
1. Enter 676.
Display: PS Incoming Disp
2. Press NEXT.
Display: PS NO?→
3. Enter the PS registration number.
You can also keep pressing NEXT until the desired PS registration
number is displayed.
Display example: PS01: Caller
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another PS, press NEXT or PREV, or SELECT
and the desired PS registration number.
7. Repeat steps 4 through 6.
8. Press END.
• To assign all PSs to one selection, press the
case, the display shows the contents programmed for the PS which has
the lowest PS registration number.
• If the receiving call is in the 1:N status, the display only shows "CO
Line."
Section 3, Features,
CO Incoming Call Information Display
Display, Call Information
KX-TD1232 – 01 through 64,
( =all PS registration numbers)
key in step 3. In this
DECT Portable Station Section
676
8-67