Panasonic KX-TD1232E Installation Manual page 572

8.2.4 Installing the Unit 8.2.4 Installing the Unit
6. Wireless Extension Connection
Use a Cell Station Cord (4-conductor wiring – included) and 4-pin plug (included) to connect
the cell station line. There are 2 plugs for the KX-TD144 and 6 plugs for the KX-TD146 to
connect the Cell Stations.
Maximum length of the cable: AWG 24 (ø 0.6 mm): Under 1 km
KX-TD144
To the Cell Station
Connect the ground terminal to ground.
Note: If other expansion units are
installed, the frame ground connection
is required for only one unit.
8-14 DECT Portable Station Section
6-1. Insert the wires of the 4-conductor wiring cord into the holes
in the plug to connect pins "D1", "D2", "V1" and "V2".
D1: Data 1
D2: Data 2
Press the transparent part into the black part.
Insert the other end of the wires into the modular plug.
Note: Do not peel off the wire coating. Insert the wires all the way.
2
4-pin plug
D1
V1
V2
D2
6-2. Insert the 4-pin plug into a cell station jack on the unit, and
attach the ferrite core (included) to the plug cord.
CS
no.
D1
V1
2
V2
D2
1
5 cm
Ferrite Core
Roll the cord once around
the ferrite core and close
the core.
Note: Put it in the cabinet
when closing the cabinet cover.
V1: Voltage +
V2: Voltage –
1
KX-TD146
Modular plug
D1
V1
V2
D2
CS
no.
D1
V1
6
V2
D2
5
4
3
2
1