Class Of Service - Panasonic KX-TD1232E Installation Manual

4.8 Extension Programming
Description
Selection
Default
Programming
Conditions
Feature References

Class of Service

Programs each extension for a Class of Service (COS). The COS
determines the call handling abilities of each extension.
A primary and a secondary COS numbers can be assigned per
extension.
• Jack number: KX-TD816 – 01 through 16,
KX-TD1232 – 01 through 64,
( =all jacks, -1 = first part, -2 = second part)
• COS number: 1 through 8
All jacks-1/2 – COS 1, COS 1
1. Enter 601.
Display: COS Assign
2. Press NEXT.
Display: Jack NO?→
3. Enter a jack number.
To enter jack number 01, you can also press NEXT.
To select the second part (-2), press NEXT after entering a jack number.
Display example: #01-1:COS1, COS1
4. Enter a COS number for primary number.
To change the current entry, enter the new number.
5. Press .
6. Enter a COS number for secondary number.
To change the current entry, enter the new number.
7. Press STORE.
8. To program another jack, press NEXT or PREV, or
SELECT and the desired jack number.
9. Repeat steps 4 through 8.
10. Press END.
• There is a maximum of eight Classes of Services. Every extension must
be assigned to a Class of Service and is subject to the COS Programming
of programs [5XX] and [991]. The restriction of program [991], bits 1
through 4, applies only for analogue outside lines.
• In the case of KX-TD1232, jack numbers 01 through 32 are for the
Master System and 33 through 64 are for the Slave, if available. Jack
numbers in the out-of-service system are unacceptable.
• For an explanation of jack numbering, see "Rotation of jack number"
on page 4-7.
• To assign all jacks to one COS, press the
the display shows the contents programmed for Jack 01.
Section 3, Features,
Class of Service (COS)
(-1 / -2),
(-1 / -2),
key in step 3. In this case,
System Programming
601
4-127