Panasonic KX-TD1232E Installation Manual page 82

2.4.9 9600bps Speed Remote Unit* /
Message Unit Installation
Preparation
KX-TD198 (KX-TD816 only)
It is necessary to set the MODE switch
before installing the Remote Unit to the
KX-TD816.
1. Remove the front cover of the Remote
Unit.
2. Set the MODE switch to 1.
MODE
1 2
2-46 Installation
The following preparations are necessary before installing the
9600bps Speed Remote Unit (KX-TD198) or Message Unit (KX-
TD190).
It is possible to attach another expansion unit
to the Message or Remote Unit and install
them to the system. In this case, the following
procedures are necessary.
1. Remove the front cover of the Message or
2. Attach the expansion unit to the Message
Message/Remote unit
cabinet cord
Note
KX-TD190 / KX-TD198
Remote Unit.
or Remote Unit as shown below. Be sure
to connect the cabinet cords by inserting
the expansion unit cabinet cord through the
slot in the Message or Remote Unit.
Expansion unit cabinet cord
The KX-TD198 users must set the MODE
switch to 1.
*: Available for KX-TD816 only.