Panasonic KX-TD1232E Installation Manual page 654

109
Conditions
22
Expansion Unit Type
3. Keep pressing SELECT until the desired selection is
displayed.
4. Press .
5. Keep pressing SELECT until the desired selection is
displayed.
6. Repeat steps 4 and 5 until all of the required entries are
completed.
7. Press STORE.
If only one system is in operation, go to step 8.
8. Press NEXT to program the Slave System.
Display example: Slave :C ;C; E1; E2
9. Repeat steps 3 through 7.
10. Press END.
• When starting the system for the first time or performing System Data
Clear, the application for location will use practical installation instead
of the system default setting.
• For KX-TD816, there is one expansion area inside the system, area 1,
and there are two expansion areas on the system, areas 2 and 3 from
bottom to top.
• For KX-TD1232, there is one expansion area inside the system, area 1,
and there are three expansion areas on the system, area 2, 3 and 4 from
bottom to top.
• If the Slave system is out-of-service, skip steps 8 and 9.
• After changing the setting, to make your setting effective, turn the
Power Switch off and an again. Otherwise, the previous setting will be
maintained.
Note:
After assigning a KX-TD184 in this program register, turn the Power
Switch off and on again. Otherwise the previous setting will be
maintained.
System Programming
(contd.)