Chapter 4 Device Management; Introduction To Device Management - H3C S7500 Series Operation Manual

Operation Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches

Chapter 4 Device Management

When configuring device management, go to these sections for information you are
interested in:

Introduction to Device Management

Device Management Configuration
Configuring Pause Frame Protection Mechanism
Configuring Layer 3 Connectivity Detection
Configuring Queue Traffic Monitoring
Configuring Error Packets Monitoring
Displaying the Device Management Configuration
Remote Switch Update Configuration Example
Note:
When different engines work together with a chassis, note that:
If the Salience III series engines and Salience III Edge engines work with the S7506R
chassis without the XGbus silkscreen, the four SFP interfaces on the engine do not
work.
If a Salience III engine or a Salience III Edge engine works with S7506R XGbus chassis,
the four SFP interfaces on the engine all work normally.
When two Salience III engines or two Salience III Edge engines are inserted into the
S7506R XGbus chassis,
The first two SFP interfaces of the primary board and the first two SFP interfaces of
the secondary board work normally. Services will not be interrupted during
active-standby switchover.
The last two SFP interfaces on the primary board and the last two interfaces on the
secondary board do not work, and you can not see these four interfaces through
command line interface.
When the secondary board is inserted, configurations on the last two SFP interfaces
of the primary board will not be sent to the first two SFP interfaces of the secondary
board automatically, and you need to do this manually.
4.1 Introduction to Device Management
The device management function of the Ethernet switch can report the current status
and event-debugging information of the boards to you. Through this function, you can
4-1
Chapter 4 Device Management