Table of Contents
Advertisement
1. Read "Safety" on page v and the "Installation guidelines" on page 239.
2. Lower the cover so that the slots at the rear slide down onto the pins at the
3. Pivot the cover to the closed position until it clicks into place.
4. Install the blade server into the BladeCenter unit. See "Installing the blade
Removing the bezel assembly
Remove the bezel assembly.
Control-panel
cable
Figure 10. Removing the bezel assembly
1. Read "Safety" on page v and the "Installation guidelines" on page 239.
2. Shut down the operating system, turn off the blade server, and remove the
3. Carefully lay the blade server on a flat, static-protective surface, with the cover
4. Open and remove the blade server cover. See "Removing the blade server
5. Press the bezel-assembly release on each side of the blade server and pull the
6. Disconnect the control-panel cable from the control-panel connector.
7. Pull the bezel assembly away from the blade server.
8. If you are instructed to return the bezel assembly, follow all packaging
246
JS12 Type 7998: Problem Determination and Service Guide
rear of the blade server. Before you close the cover, verify that all components
are installed and seated correctly and that you have not left loose tools or parts
inside the blade server.
server in a BladeCenter unit" on page 242.
Bezel-assembly
release
Control-panel
connector
blade server from the BladeCenter unit. See "Removing the blade server from a
BladeCenter unit" on page 241.
side up.
cover" on page 244.
bezel assembly away from the blade server approximately 1.2 cm (0.5 inch).
instructions, and use any packaging materials for shipping that are supplied to
you.
Bezel-assembly
release
Bezel
assembly
Advertisement
Table of Contents
