Table of Contents
Advertisement
1. Read "Safety" on page v and the "Installation guidelines" on page 239.
2. Shut down the operating system, turn off the blade server, and remove the
3. Carefully lay the blade server on a flat, static-protective surface, with the cover
4. Open and remove the blade server cover. See "Removing the blade server
5. Locate the management card connector.
6. Carefully open the retaining clips on each end of the management card
7. If you are instructed to return the management card, follow all packaging
8. Move the management card to a new system board and chassis assembly.
Installing the management card
Use this procedure to install the management card into the currently installed
system board. If you are also installing a new system board, you must complete
this procedure before installing the new system board.
To install the management card, complete the following steps.
Figure 17. Installing the management card
254
JS12 Type 7998: Problem Determination and Service Guide
blade server from the BladeCenter unit. See "Removing the blade server from a
BladeCenter unit" on page 241.
side up.
cover" on page 244.
See "System-board connectors" on page 9 for the management card slot
location.
Attention: To avoid breaking the card retaining clips or damaging the
management card connectors, open and close the clips gently.
connector and remove the management card.
instructions, and use any packaging materials for shipping that are supplied to
you.
If you are directed to move the management card to a new system board and
chassis assembly, perform the following procedure.
a. Replace the system board and chassis assembly, as described in "Replacing
the Tier 2 system-board and chassis assembly" on page 274.
b. Replace the management card, as described in "Installing the management
card."
Management
card
Retaining clip
Advertisement
Table of Contents
