IBM BladeCenter JS12 Problem Determination And Service Manual page 187

Table 25. A00-FF0 through A24-xxx SRNs (continued)
SRN Description
A13-06x A non-critical error has been detected, a
mezzanine bus address parity error.
A13-07x A non-critical error has been detected, a
system bus address parity error.
A13-09x A non-critical error has been detected, a
system bus data parity error.
A13-11x A non-critical error has been detected, a
system bus time-out error
A13-12x A non-critical error has been detected,
an error on system bus.
A13-13x A non-critical error has been detected,
an I/O expansion bus parity error.
A13-14x A non-critical error has been detected,
an I/O expansion bus time-out error.
A13-15x A non-critical error has been detected,
an I/O expansion bus connection
failure.
FRU/action
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
Chapter 2. Diagnostics
173