IBM BladeCenter JS12 Problem Determination And Service Manual page 174

Ibm power6 architecture
Table of Contents

Advertisement

Note: Some SRNs in this sequence might have 4 rather than 3 digits after the dash
(–).
Table 24 shows the meaning of an x in any of the following SRNs, such as A01-00x.
Table 24. Meaning of the last character (x) after the hyphen
Number
1
2
4
8
Table 25 describes each SRN and provides a recommended corrective action.
Table 25. A00-FF0 through A24-xxx SRNs
SRN
A00-FF0
A01-00x
A01-01x
A01-02x
A01-05x
160
JS12 Type 7998: Problem Determination and Service Guide
Meaning
Replace all FRUs listed
Hot swap supported
Software might be the cause
Reserved
Description
Error log analysis is unable to
determine the error. The error log
indicates the following physical FRU
locations as the probable causes.
Error log analysis indicates an error
detected by the microprocessor, but the
failure could not be isolated.
GCPU internal error.
CPU internal cache or cache controller
error.
System bus time-out error.
FRU/action
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.

Advertisement

Table of Contents
loading

Table of Contents