Table of Contents
Advertisement
Removing the bezel assembly
To remove the bezel assembly, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Open the blade server cover (see "Removing the blade server cover" on page
3. Press the bezel-assembly release on each side of the blade server and pull the
4. Disconnect the control panel cable from the control panel connector.
5. Pull the bezel assembly away from the blade server.
6. Store the bezel assembly in a safe place.
Installing the bezel assembly
To install the bezel assembly, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Connect the control panel cable to the control panel connector on the system
3. Carefully slide the bezel assembly onto the blade server until it clicks into place.
Bezel-assembly
release
Control panel
connector
on page 55.
59 for instructions).
bezel assembly away from the blade server approximately 1.2 cm (0.5 inch).
Bezel-assembly
release
Control panel
connector
on page 55.
board.
Bezel-assembly
release
Control-panel
cable
Bezel-assembly
release
Control-panel
cable
Chapter 4. Removing and replacing blade server components
61
Advertisement
Table of Contents
