Removing The Blade-Server Bezel Assembly; Installing The Ide Hard Disk Drive - IBM BladeCenter QS20 Problem Determination And Service Manual

Removing the blade-server bezel assembly

Before you can replace a defective system-board assembly or blade-server bezel
assembly, you must first remove the blade-server bezel assembly. The following
illustration shows how to remove the bezel assembly from a blade server.
Figure 8. Removing the bezel assembly
Complete the following steps to remove the blade-server bezel assembly:
1. Read the safety information beginning on page vii and "Installation guidelines"
2. Open the blade server cover.
3. Press the bezel-assembly release and pull the bezel assembly away from the
4. Disconnect the control panel cable from the control panel connector.
5. Disconnect the serial cable from the serial connector.
6. Pull the bezel assembly away from the blade server.
7. Store the bezel assembly in a safe place.

Installing the IDE hard disk drive

The blade server has a connector on the system board for installing a 2.5-inch
integrated drive electronics (IDE) hard disk drive. The BladeCenter QS20 model
comes with the IDE hard disk drive already installed.
Note: Some hard disk drives have Phillips screws; therefore, make sure that a
Attention:
unit for more than 1 minute without a blade server or filler blade installed in each
blade bay.
Bezel release buttons
Control panel
connector
on page 39.
blade server approximately 1.2 cm (0.5 inch).
Phillips screwdriver is available.
To maintain proper system cooling, do not operate the BladeCenter
Bezel release buttons
Serial
connector
Front bezel
Control panel
cable
Chapter 5. Installing and removing replaceable units
Serial
cable
45