Table of Contents
Advertisement
Table 23. 101-711 through FFC-725 SRNs (continued)
SRN
FFC
254E-702
254E 221
2567–xxx
256D-201
256D 221
256D-601
256D
256D-602
256D
256D-603
256D
256D-604
256D 210
256D-605
256D
256D-606
256D
256D-701
256D 221
Description and Action
Error log analysis indicates permanent adapter failure is reported on the other port
of this adapter. Go to "Performing the checkout procedure" on page 187.
USB integrated system-board and chassis assembly. Go to "Performing the checkout
procedure" on page 187.
Adapter configuration error.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Error log analysis indicates adapter.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Error log analysis indicates an error attention condition.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Error Log Analysis indicates that the microcode could not be loaded on the adapter.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Error Log Analysis indicates a permanent adapter failure.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Error Log Analysis indicates permanent adapter failure is reported on the other port
of this adapter.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Error Log Analysis indicates adapter failure.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Error Log Analysis indicates permanent adapter failure.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
155
Chapter 2. Diagnostics
Advertisement
Table of Contents
