Table of Contents
Advertisement
Cover pins
Figure 10. Removing the expansion unit
Complete the following steps to remove BladeCenter PCI Express I/O Expansion
Unit:
1. Read the safety information beginning on page vii and "Installation guidelines"
2. Carefully place the blade server on a flat, static-protective surface, with the
3. Press the blue blade cover release on each side of the blade server and lift the
4. To remove the expansion unit, carefully lift it from the cover pins and set it
Removing the blade-server front bezel assembly
Before you can add, remove, or replace system memory DIMM modules, replace a
defective system board assembly, or replace the blade server front bezel assembly,
you must first remove the blade server front bezel assembly.
Cover release
on page 19.
expansion unit side facing up.
expansion unit (see Figure 10).
aside.
Cover release
Chapter 4. Installing and removing replaceable units
23
Advertisement
Table of Contents
