Removing The Bezel Assembly - IBM BladeCenter PN41 Problem Determination And Service Manual

To connect the transceiver module cable, complete the following steps:
1. Remove the protective caps from the ends of the fiber-optic cable.
2. Gently slide the fiber-optic cable into the transceiver module until it clicks into
3. Check the LED next to the port connector on the DPI blade bezel. When the

Removing the bezel assembly

The following illustration shows how to remove the bezel from the DPI blade.
To remove the bezel, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. If the DPI blade is installed in a BladeCenter unit, remove it. See "Removing the
36
IBM BladeCenter PN41 Type 3020 Deep Packet Inspection Blade: Problem Determination and Service Guide
Fiber-optic
cable
place. (The following illustration shows an XFP module and cable.)
transceiver module is operating correctly, the green link LED is lit.
Bezel-assembly
release (both sides)
on page 25.
DPI blade from the BladeCenter unit" on page 27 for more information.
Protective cap
Control-panel
cable
Bezel
Control-panel
connector