Table of Contents
Advertisement
Installing the bezel assembly
Install the bezel assembly.
Control-panel
connector
Control-panel
cable
Figure 11. Installing the bezel assembly
1. Connect the control-panel cable to the control-panel connector on the system
board.
2. Carefully slide the bezel assembly onto the blade server until it clicks into
place.
3. Install and close the blade server cover. See "Installing and closing the blade
server cover" on page 245.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade server cover before installing the blade
server.
4. Install the blade server into the BladeCenter unit. See "Installing the blade
server in a BladeCenter unit" on page 242.
Bezel-assembly
release
Bezel
assembly
Chapter 4. Removing and replacing blade server components
Bezel-assembly
release
247
Advertisement
Table of Contents
