Table of Contents
Advertisement
Table 14. BA000010 to BA400002 Partition firmware SRCs (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
v See Chapter 3, "Parts listing, Type 7998," on page 235 to determine which components are CRUs and which
components are FRUs.
Error code
BA040040
BA040050
BA040060
BA050001
BA050004
BA05000A
BA060008
BA06000B
BA06000C
62
JS12 Type 7998: Problem Determination and Service Guide
Description
Setting the machine type, model, and
serial number failed.
The h-call to switch off the boot
watchdog timer failed.
Setting the firmware boot side for the
next boot failed.
Failed to reboot a partition in logical
partition mode
Failed to locate service processor device
tree node.
Failed to send boot failed message
No configurable adapters found by the
Remote IPL menu in the SMS utilities
The system was not able to find an
operating system on the devices in the
boot list.
A pointer to the operating system was
found in non-volatile storage.
Action
1. Go to "Checkout procedure" on page 186.
2. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly"
on page 274.
1. Go to "Checkout procedure" on page 186.
2. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly"
on page 274.
1. Go to "Checkout procedure" on page 186.
2. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly"
on page 274.
1. Go to "Checkout procedure" on page 186.
2. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly"
on page 274.
1. Go to "Checkout procedure" on page 186.
2. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly"
on page 274.
1. Go to "Checkout procedure" on page 186.
2. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly"
on page 274.
This error occurs when the firmware cannot
locate any LAN adapters that are supported by
the remote IPL function. Verify that the devices
in the remote IPL device list are correct using
the SMS menus.
Go to "Boot problem resolution" on page 193.
1. Go to "Checkout procedure" on page 186.
2. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly"
on page 274.
Advertisement
Table of Contents
