Table of Contents
Advertisement
Table 13. B700xxxx Licensed internal code SRCs (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
v See Chapter 3, "Parts listing, Type 7998," on page 235 to determine which components are CRUs and which
components are FRUs.
B700 xxxx Error Codes
5302
5303
5400
5442
54DD
5600
5601
6900
6906
6907
6908
44
JS12 Type 7998: Problem Determination and Service Guide
Description
An unsupported Preferred Operating
System was detected.
The Preferred Operating System
specified is not supported. The IPL will
not continue.
An unsupported Preferred Operating
System was detected.
The Preferred Operating System
specified is not supported. The IPL will
continue.
System firmware detected a problem
with a processor.
System firmware detected an error.
Informational system log entry only.
Informational system log entry only.
System firmware failure. There was a
problem initializing, reading, or using
system location codes.
PCI host bridge failure
System bus error
System bus error
System bus error
Action
Work with IBM support to select a supported
Preferred Operating System; then, re-IPL the
system.
Work with IBM support to select a supported
Preferred Operating System; then, re-IPL the
system.
Replace the system-board and chassis
assembly, as described in "Replacing the Tier 2
system-board and chassis assembly" on page
274.
Replace the system-board and chassis
assembly, as described in "Replacing the Tier 2
system-board and chassis assembly" on page
274.
No corrective action is required.
No corrective action is required.
Go to "Isolating firmware problems" on page
222.
1. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly"
on page 274.
2.
If the problem persists, use the "PCI
expansion card (PIOCARD) problem
isolation procedure" on page 200 to
determine the failing component.
Replace the system-board and chassis
assembly, as described in "Replacing the Tier 2
system-board and chassis assembly" on page
274.
1. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly"
on page 274.
2. Go to "Isolating firmware problems" on
page 222.
Replace the system-board and chassis
assembly, as described in "Replacing the Tier 2
system-board and chassis assembly" on page
274.
Advertisement
Table of Contents
