Removing the blade server bezel assembly
To install certain options you must first remove the blade server bezel assembly.
The following illustration shows how to remove the bezel assembly from a blade
server.
Complete the following steps to remove the blade server bezel assembly:
1. Review the information in "Safety" beginning on page v and "Installation
2. Open the blade server cover.
3. Press the bezel-assembly release and pull the bezel assembly away from the
4. Disconnect the control-panel cable from the control-panel connector.
5. Pull the bezel assembly away from the blade server chassis.
6. Store the bezel assembly in a safe place.
Installing IDE hard disk drives
Your blade server has two connectors on the system board for installing optional
2.5-inch IDE hard disk drives. Each IDE connector is on a separate bus. Some
models come with at least one IDE hard disk drive already installed.
Attention:
unit for more than 1 minute without either a blade or a filler blade installed in each
blade bay.
18
BladeCenter HS20 Type 8678: Installation and User's Guide
Bezel-assembly
release
Control panel
connector
guidelines" on page 15.
blade server chassis approximately 1.2 cm (0.5 inch).
To maintain proper system cooling, do not operate the BladeCenter
Bezel-assembly
release
Control-panel
cable