Table of Contents
Advertisement
Table 25. A00-FF0 through A24-xxx SRNs (continued)
SRN
A11-550
A12-00x
A12-01x
A12-02x
A12-03x
A12-04x
A12-05x
A12-06x
170
JS12 Type 7998: Problem Determination and Service Guide
Description
Recoverable errors on resource indicate
a trend toward an unrecoverable error.
However, the resource could not be
deconfigured and is still in use. The
system is operating with the potential
for an unrecoverable error.
A non-critical error has been detected.
Error log analysis indicates an error
detected by the memory controller, but
the failure could not be isolated.
A non-critical error has been detected,
an uncorrectable memory error.
A non-critical error has been detected,
an ECC correctable error.
A non-critical error has been detected, a
correctable error threshold exceeded.
A non-critical error has been detected, a
memory control subsystem internal
error.
A non-critical error has been detected, a
memory address error (invalid address
or access attempt).
A non-critical error has been detected, a
memory data error (bad data going to
memory).
FRU/action
1. If repair is not immediately available, reboot
and the resource will be deconfigured;
operations can continue in a degraded mode.
2. Check the BladeCenter management-module
event log for an entry around this time. If no
entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
Advertisement
Table of Contents
