Table of Contents
Advertisement
4. Install the blade server into the BladeCenter unit. See "Installing the blade
Removing the expansion bracket
You can remove the expansion bracket.
Expansion bracket
Figure 28. Removing the expansion bracket
Perform the following procedure to remove the expansion bracket.
1. Read "Safety" on page v and the "Installation guidelines" on page 239.
2. Shut down the operating system, turn off the blade server, and remove the
3. Carefully lay the blade server on a flat, static-protective surface, with the cover
4. Open and remove the blade server cover. See "Removing the blade server
5. If a standard-form-factor expansion card is installed, remove it. See "Removing
6. Remove the two screws that secure the expansion bracket to the system board
7. If you are instructed to return the expansion bracket, follow all packaging
272
JS12 Type 7998: Problem Determination and Service Guide
server in a BladeCenter unit" on page 242.
blade server from the BladeCenter unit. See "Removing the blade server from a
BladeCenter unit" on page 241.
side up.
cover" on page 244.
a standard-form-factor expansion card" on page 263.
and remove the expansion bracket.
instructions, and use any packaging materials for shipping that are supplied to
you.
Advertisement
Table of Contents
