Table of Contents
Advertisement
Table 25. A00-FF0 through A24-xxx SRNs (continued)
SRN
Description
A0D-09x
Service Processor error accessing Vital
Product Data EEPROM.
A0D-18x
Service Processor detected NVRAM
error.
A0D-19x
Service Processor error accessing Real
Time Clock/Time-of-Day Clock.
A0D-21x
Service Processor detect error with
Time-of-Day Clock backup battery.
A0D-23x
Loss of heart beat from Service
Processor.
A0D-24x
Service Processor detected a
surveillance time-out.
A0D-31x
Error detected while handling an
attention/interrupt from the system
hardware.
A0D-35x
Mainstore or Cache IPL Diagnostic
Error.
FRU/action
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
Chapter 2. Diagnostics
167
Advertisement
Table of Contents
